~ outback
front hps hawk brake pads 1996-1996 Subaru Legacy Wagon - Exc. Gt, L ~
lsi. ~ HPS - High Performance Street Superior Stopping Power HPS - High Performance Street disc brake pads are world renowned for increasing stopping power on your street legal vehicle. ~ Increasing the performance of your vehicles braking system is easy when you choose Hawk Performance?s HPS braking compound. ~ This unique Ferro-Carbon formula was developed for street performance using the safety and quality of Aerospace and Motorsports severe-duty friction technology. ~ The High Performance Street compound offers a higher coefficient of friction over stock brake pads and can provide you 20-40% more stopping power and higher resistance to brake fade than most standard replacement pads. ~ Less fade means you?ll have a highly durable brake pad with less brake dust.. ~ HPS Ferro-Compound Features: ? Increased stopping power ? High friction/torque hot or cold ? Gentle on rotors ? Extended pad life ? Low dust ? Virtually noise-free All Hawk Performance High Performance Street brake pads provide a limited lifetime warranty, ensuring products to be free of defects from manufacturer?s workmanship and materials. ~ Note: Hawk Performance burnishes its High Performance Street brake pads as a final step in the factory, but all brake pads have to be bedded-in with the rotors (new or used) that they will be used against. ~ Properly bedding-in new brake pads results in a transfer film being generated at the pad and rotor interface to maximize brake performance. ~ Brake Pad Installation Procedure 1. ~ Install brake pads properly. ~ Be sure pads are securely positioned in the caliper. ~ 2. ~ Flush system with fresh brake fluid. ~ 3. ~ Check all hydraulic parts for excess wear and tear. ~ 4. ~ Check disc for proper thickness, parallelism, and lateral runout. ~ 5. ~ Check disc for scoring or grooves over .012?depth. ~ If either applies, resurfacing is required. ~ 6. ~ If discs do not need resurfacing, then contamination from the previous brake pads must be removed. ~ Sand discs with 130 grit sandpaper using moderate pressure. ~ Use soap and water to clean discs? surface after sanding and machining. ~ Discs should be free and clear of oil, grease, and brake fluid. ~ 7. ~ Inspect calipers for freedom of movement. ~ Lubricate where necessary. ~ Burnishing Instructions 1. ~ After installing new brake pads, make 6 to 10 stops from approximately 30-35 mph applying moderate pressure. ~ 2. ~ Make an additional 2 to 3 hard stops from approximately 40 to 45 mph. ~ 3. ~ DO NOT DRAG BRAKES! 4. ~ Allow 15 minutes for brake system to cool down. ~ 5. ~ After step 4 your new pads are ready for use. ~ outback front hps hawk brake pads; lsi; 1996-1996 subaru legacy wagonexc. ~ gt;